To select your supported launch monitor choose from the drop down list. See the window below. Select apply to change, then go to your specific launch monitor to the left to make changes to its settings.

 

launchsettings

 

· Trackman TPS software – You will also need to select enable SDK in the TPS software.
· Trackman settings>if you have trackman 2 or 3 then you will need to set the Ip address to 127.0.0.1 and port to 52950 as in the picture below.
· However if you have trackman 3e and connect with a cable then the ip address needs to be 169.254.0.1
· If WiFi the IP address is 170.30.20.1
· Note: When using the trackman as a launch monitor and you miss the start of the swing you should alter the seconds before hit to 2 seconds and after hit to 1 – 1.5 seconds. Each system may vary slightly.
· You also have the option In GASPLab4 in Settings>Capture>the reset after record should be de-selected.
· Either manual or hit mic capture in the hit detection settings.

tmsettings

Foresight GC2 – There are no changes to be made when using the GC2 in Gasplab4.

 

Foresight GC2 CSV – Using this setting allows you to run the Foresight GC2 software in Club Fit Mode and GASPLab 4. The data from the GC2 will be transferred to the video clips after the shot/video clips have been captured.

Note:

· Always open Foresight Sports GC2 software first prior to opening GASPlab4.
· Make sure in the GC2 software settings the output to CSV file is selected.
· In GASPLab in Settings>Capture>the reset after record should be de-selected. If this feature is selected then the data from the GC2 will not be transferred. (See below).
· As the data transfers 6 seconds after impact in this mode you will have to be able to use the Launch monitor after impact.
· Either manual or hit mic capture in the hit detection settings.

gc2csv

foresightlastshot

 

· Select under launch monitor Foresight Sports GC2 CSV. This shows the files location of the Foresight GC2 last shot file. Use c:\program files (x86)\Foresight\System if using windows 64 bit and c:\program files\Foresight\System if using Windows 32 bit,

foresightlastshot1

Flightscope – In the device setting select the device and how its connected. The Wifi ports if using wifi. Mode>distance to tee, club and altitude.

 flightscopesettings